Training Modules

The Introduction to CCTV course is designed for novices not yet familiar with CCTV. This course starts right from the basics, such as what makes up a Surveillance System, right through to recording DVR Systems, resolutions and features. If you are new to the Surveillance industry, then this is the course for you.

Topics Covered:

  • What makes up a CCTV system
  • Key differences between Video Formats (AHD, TVI and HDCVI)
  • Focal length and lens choice
  • Infra Red
  • CCTV connectors, cable and power
  • CCTV DVR recording solutions
The Introduction to Networking course is designed for novices not yet familiar with CCTV Networking. This course starts right from the basics, such Local Area Network (LAN) creation, right through to Wide Area Networks (WAN) and features. If you are new to CCTV Networking , then this is the course for you

Topics Covered:

  • What is a network(LAN and WAN)
  • Bandwidth
  • Network Design and Addressing
  • Hardware
  • Cabling
  • POE (Power over Ethernet)
The Remote View Setup course covers the fundamentals of accessing your Surveillance System Remotely.

Topics Covered:

  • Setup your DVR/NVR onto the Local Area network
  • Port-forwarding on your router
  • Configuring DDNS Setup
  • CMS Software and Application Setup
The Introduction to IP Camera Systems course covers the fundamentals of sending video over an IP network. We will look at the component parts of the IP system, how video can impact your network and how we can maximize efficiency. We combine both theoretical and practical exercises to illustrate the differences in technologies and how to go about designing basic networks for CCTV.

Topics Covered:

  • Hardware Installation
  • Cabling and Switch Selection
  • Network Design and Addressing
The AVTECH CCTV Training covers the fundamentals of Setting Up and Operating your AVTECH Surveillance System.

Topics Covered:

  • General Settings
  • Recording Settings(Manual, Motion and Schedule)
  • Playback and Back Up Procedures
  • Easy networking
  • Push Video and Status
  • Video Analytic's(Virtual Fence, People Counting, One Way)
  • Event and System Logs
  • User Accounts
  • HDD Manager
The AUGEN CCTV Training covers the fundamentals of Setting Up and Operating your AUGEN Surveillance System.

Topics Covered:

  • General Settings
  • Recording Setting(Manual, Motion and Schedule)
  • Playback and Back Up Procedures
  • Event and Systems Logs
  • User Accounts
  • HDD Manager

Booking Form

Use the simple booking form below to book your training session with Illuder.